SOLAC Optima Start PV2004 Instrucciones De Uso página 7

Press the steam blast button ( B ). Wait a few
•
seconds until the steam penetrates the fibres
of the garment before pushing the button
again. For optimum steam quality, do not apply
more than three successive blasts.
The spray button has to be pressed repeatedly
•
to release the first spray.
VERTICAL IRONING:
It is possible to iron hanging curtains, items of
•
clothing on their own hanger, etc. To do so, fol-
low these instructions:
Select the iron's maximum temperature by
•
turning the iron's temperature regulator clock-
wise. (Fig 2)
Iron from top to bottom while pressing the
•
steam control ( B ). Important: for cotton and
linen, it is recommended to put the base of the
iron in contact with the material. For other more
delicate fabrics, it is recommended to keep the
base of the iron a few centimetres away.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Select the minimum position (MIN) using the
•
thermostat control.
Unplug the appliance from the mains.
•
Remove the water from the water tank.
•
Clean the appliance
•
CLEANING
Unplug the appliance from the mains and let
•
it cool down before performing any cleaning
task.
Clean the appliance using a damp cloth with a
•
few drops of detergent and then dry it.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive prod-
ucts, for cleaning the appliance.
Do not immerse the appliance in water or any
•
other liquid, or place it under a running tap.
SEF-CLEANING FUNCTION:
It is important to self-clean the appliance at
•
least once a month to remove calcium and any
other built-up minerals inside the iron.
Fill the water tank to its maximum level, as indi-
•
cated in the "filling with water" section.
Place the iron in an upright position, plug in to
•
the mains and select maximum temperature.
Leave the appliance to heat up until the pilot
•
light indicates that it has reached its consigned
temperature.
Unplug the appliance and place it in the sink.
•
Press and hold the self-clean button (Fig. 6).
•
Let the water flow out through the steam vents
•
in the base, while lightly shaking the appliance
(Fig. 7).
Release the button after a minute or when the
•
tank becomes empty.
Leave the iron in the upright position until it has
•
cooled.
* HOW TO DEAL WITH LIME SCALE IN-
CRUSTATIONS:
For the appliance to work correctly it should be
•
kept free of lime scale or magnesium incrusta-
tions caused by the use of hard water.
To prevent this kind of problem, we recom-
•
mend the use of water with low lime or magne-
sium mineralisation.
Homemade solutions are not recommended
•
for de-scaling this appliance, such as the use
of vinegar.
EN