Descargar Imprimir esta página

Futurelight WDS-1 W-DMX Sender Manual Del Usuario página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with quick link with screw cap. Pull the safety-rope through the attachment eyelet
on the device and over the trussing system or a safe fixation spot. Insert the end in the quick link and tighten
the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already held the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
5.2 DMX-512 connection
The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the wireless sender or one fixture with another.
Occupation of the XLR-connection:
DMX-output
XLR mounting-socket:
1: Ground
2
1
2: Signal (–)
3
3: Signal (+)
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
6. OPERATION
After you connected the device to the mains, the WDS-1 is ready for use. Switch the device on via the
Power-switch.
DANGER TO LIFE!
the fixtures will not work at all, or will not work properly.
DMX-input
XLR mounting-plug:
1: Ground
2
1
2: Signal (–)
3
3: Signal (+)
Screw one clamp each via a M12 screw and nut
onto the Omega-holder.
Insert the quick-lock fasteners of the Omega-
holder into the respective holes on the bottom of
the device. Tighten the screws fully clockwise.
15/31
00015828.DOC Version 2.0

Publicidad

loading