5
Engine will start.
After pulling starting rope gently by two or
three times, pull it hard to start the engine.
[Pulling method for starting rope]
1. Grasp starting rope tight with right hand.
2. Hold chemical tank with left hand.
3. Pull starting rope slowly until resistance is felt.
4. Pull starting rope straight from entrance of
starter.
5. Do not pull starting rope to the end.
6. Do not release the starter rope handle when
rope is extended. Allow the recoil to rewind the
rope gradually.
CAUTION
CAUTION
If the engine does not start by repeated action,
try pulling the rope after fully opening the choke.
※ If the engine still does not start, refer to
page 15.
English
6
Return choke slowly.
CAUTION
・Frequent operation of choke when starting the
engine causes too much fuel to be sucked in,
making the engine difficult to start. In that
case, start with the choke in the fully open
position.
・After starting the engine, accelerate bit by bit
quickly by opening and closing the throttle
lever several times.
・This operation is to bleed air in the carburetor.
When there is air present, there is the possi-
bility of poor acceleration and engine stalling.
・Always prime the cabretor before use. This
will make starting next time easy.
When the engine is warming, you can start it by
pulling the starting rope vigorously forward with
this product on the back.
11