Publicidad
Idiomas disponibles
Idiomas disponibles
Wait 3 minutes before resuming operation
After the unit has stopped, it can not be restart
operation in the first 3 minutes.This is to protect the
unit. Operation will automatically start after 3 minutes.
Removing the collected water
There are two ways to remove collected water.
1. Use the bucket
· When the bucket is full, the unit will automatically
stop running, and the Full indicator light will flash.
· Slowly pull out the bucket. Grip the left and right
handles securely , and carefully pull out straight so
water does not spill. Do not put the bucket on the
floor because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water to
spill.
· Throw away the water from the water outlet and
replace the bucket. The bucket must be in place and
securely seated for the dehumidifier to operate.
· The machine will re-start when the bucket is restored
in its correct position.
Note:
· When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
· Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
· When you remove the bucket, if there is some water in
the unit you must dry it.
2. Continuous draining
Water can be automatically emptied into a floor drain
by attaching the unit with a water hose(Φ16.5*13.5
mm)(not included).
· Remove the rubber plug from the back of the unit
and store it in a safe location.
· Insert the water hose into
the unit from the drain
outlet in the back of the
unit.
· Attach the water hose to
the drain hose outlet of
the unit.
· Make sure the connection of the water hose and the
drain hose outlet of the unit is tight and do not let the
water leak.
· Then lead the water hose to the floor drain or a
Auto-Restart
If the unit breaks off unexpectedly due to the power
cut, it will restart with the previous function setting
automatically when the power resumes.
1. Pull out the bucket a little.
2. Hold both sides of the bucket with even strength,
and pull it out from the unit.
3. Pour the water out.
suitable drainage facility .The drainage facilify should
be lower than the drain outlet of the unit. Be sure to
run the water hose sloping downward and let the
water to flow out smoothly . Do not install the water
hose.
Remove the
rubber plug
Insert the
water hose
from the
drain outlet
Do not block water flow by a rise.
· Make sure the water hose is lower than the drain hose
outlet.
Note: When the continuous drain feature is not being
used,remove the drain hose from the outlet and
attach the rubber plug back to the drain outlet.
V.1
W ater outlet
Do not block water flow by a retortion.
Page 15
Publicidad
