DeWalt DCST922 Manual De Instrucciones página 10

English
the pole completely until the guard
into place over the rear of the battery housing
Fig. B
Attaching the Auxiliary Handle (Fig. A, C)
1. Place the auxiliary handle
so the upper trimmer pole
2. Hold the auxiliary handle in place and slide the handle
bolts 24 into the handle from the top, threading them
into the handle base.
3. Tighten the handle bolts with the supplied hex wrench .
Ensure the handle is securely attached.
Fig. C
24
4
Attaching Guard (Fig. D, E)

WARNING:
Damage or personal injury could result.

WARNING:
APPLIANCE WITHOUT GUARD FIRMLY IN PLACE.
The guard must always be properly attached on the
appliance to protect the user.
1. Assemble the guard
2. Using a crosshead screwdriver, insert the 2 guard screws
21 and tighten securely.
nOTE: An extended coverage guard is available (sold
separately) for extra coverage if desired. Use replacement
guard Part Number N776035.
8
9 securely locks
7
6
8
20
4 on top of the handle base
15 is between them.
Never remove the guard.
NEVER OPERATE
9 to the motor housing
Fig. D
11 .
Fig. E
23
24
OPERATION
WARNING:

23
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. F)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
5 .
button 13
handle. Insert it into the charger as described in the charger
section of this manual
5
21
9
To reduce the risk of
12 into the tool handle, align the
and firmly pull the battery pack out of the tool