GE JGB660 Manual Del Propietário página 27

Oven Light
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the
WARNING
range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with
CAUTION
bare hands or a damp cloth can cause burns.
NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
Before replacing the bulb, disconnect electrical power to
the oven at the main fuse or circuit breaker panel. Let
the bulb cool completely before removing it. For your
safety do not touch a hot bulb with a damp cloth. If you
do the bulb may break.
To remove:
tabs of the glass cover clear the grooves of the socket
and pull the cover off. Remove the bulb.
To replace:
the glass cover into the grooves of the socket. Turn the
Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse
CAUTION
or circuit breaker panel. Be sure to let the light cover and bulb cool completely.
The oven light bulb is covered with a removable glass cover that is held in place with a bail-shaped
wire. Remove the oven door, if desired, to reach the cover easily. See the Lift-Off Oven Door
section for detailed oven door removal instructions.
Replacing the Light Bulb:
2. Hold the glass cover stable, so it doesn't fall when
released.
3. Slide near the indent of the cover holder until the
cover is released. Do not remove any screws to
release the glass cover.
bulb. Do not touch hot bulb with hand or wet
cloth. Only remove bulb when it is cool.
5. Hold glass cover stable over new bulb.
indent in the wire cover holder is located in the indent
of the glass cover.
7. Connect electrical power to range.
49-2000782 Rev. 3
NOTE:
bulb is smaller than
household bulb.
Reconnect electrical
power to the oven once
the new bulb is installed.
For improved lighting
inside the oven,
clean the glass cover
frequently using a wet
cloth. This should be
done when the oven is
completely cool.
Indent
Socket
3 "
2
Max
length
Bulb
Tab
Glass cover
Wire cover holder
27