GE JGB660 Manual Del Propietário página 28

Oven Door
For Model PGB355
The door is very heavy. Be careful when removing and lifting the door. Do not lift door by the handle.
To Remove the Door:
frame to the unlocked position.
3. Firmly grasp both sides of the door near the top.
4. Close door until the top of the door is approximately
6" from the range frame.
5. Lift door up and away from the range until both hinge
arms are clear of the slots in the range frame.
To Replace the Door:
2. With the door at the same angle as the removal
position, rest the notch on the underside of the left
hinge arm on the bottom edge of the left hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for the right side.
3. Fully open the door. If the door will not fully open, the
notches in the bottoms of the hinge arms have not
seated correctly in the bottom edge of the slot. Lift the
door off the range and repeat previous step.
down to the locked position.
5. Close the oven door.
For Models JGB660 and 735
The door is very heavy. Be careful when removing and lifting the door. Do not lift door by the handle.
To Remove the Door:
frame to the unlocked position.
3. Firmly grasp both sides of the door near the top.
4. Close door until the top of the door is approximately
6" from the range frame.
5. Lift door up and away from the range until both hinge
arms are clear of the slots in the range frame.
To Replace the Door:
2. With the door at the same angle as the removal
position, rest the notch on the underside of the left
hinge arm on the bottom edge of the left hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for the right side.
3. Fully open the door. If the door will not fully open, the
notches in the bottoms of the hinge arms have not
seated correctly in the bottom edge of the slot. Lift the
door off the range and repeat previous step.
down to the locked position.
5. Close the oven door.
28
Hinge arm
Bottom
edge of
slot
Notch
Rest notch on bottom edge
of hinge slot
Notch
Removal position
Removal position
49-2000782 Rev. 3