Publicidad
Idiomas disponibles
Idiomas disponibles
F E AT U R E S - O P E R AT I O N S
TECHNICAL SPECIFICATIONS
• Amps: 12.5
• Wattage: 1500W (+5% -10%)
• Working voltage: 120V AC/60Hz
OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Make sure the unit is in the OFF ( O ) position
before plugging the heater into the outlet.
3. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. Place heater
on a firm, level surface. At 1500 watts, this unit
draws 12.5 Amps.
Mode Control
Turn the Mode Control to the desired setting:
Figure 1
CONTROL PANEL CLOSE-UP
A
B
A. Thermostat Control
B. Mode Control
HCH 4051 heater 0/01
C
C. Power Light
O - OFF Mode
If you want to shut off the heater at any time of
operation, turn the Mode Control to OFF ( O ) position.
Power Light will remain lit until the heater is unplugged.
- Fan only Setting
Heater will run at fan-only operation without heat output.
I - LOW Heat
The heater will run continuously at 1000W.
II - HIGH Heat
The heater will run continuously at 1500W.
NOTE: To start the heater operation, make sure the
Thermostat Control is turned clockwise to the highest
position.
Thermostat Control
1. Before setting the thermostat, allow heater to operate
and warm up the room. As noted above, you need to
turn the Thermostat Control clockwise to the highest
setting to start the heater.
2. When the desired temperature comfort level is
reached, lower the thermostat setting until the power
light turns off. This is done by moving the Thermostat
Control counterclockwise toward the lowest setting.
3. The control will now automatically maintain the pre-
set temperature level by turning the heater ON and
OFF.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, you need to change the thermostat setting.
CAUTION: FRONT GRILL IS HOT WHEN UNIT IS IN
OPERATION.
Publicidad
