BH FITNESS BT7020 Manual De Instrucciones página 12

FAULT FINDING CHART
PROBLEM
1.The monitor does not
switch on.
2.The monitor switches
on but the motor fails
to start.
3.Walking motion is
jerky on the
treadmill.
4.The machine stops
(the breaker trips).
5.Electrical shocks
through the handrail.
6.The treadmill belt
skews off centre.
ERROR CODES
E1
E2
E3
E4
E5
E8
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual).
CHECKS
1) Make sure that the
machine is plugged in, the
ON/OFF switch in position 1
and that the safety key is
inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on the
sliding belt.
3.c) Check the tension on the
drive belt.
4) Check that the band is
lubricated.
5) Check that the machine is
plugged into an earthed
mains socket.
6.a) Check that the machine
is level on the floor.
6.b) Check that the machine
does not wobble.
Communication failure.
Incorrect voltage.
No speed sensor signal.
Incline failure.
Possible motor overload.
Controller failure.
SOLUTIONS
1) Plug the machine into the
mains supply. Set the switch to
position 1 and insert the safety
key.
2) Switch the machine off and
press the circuit breaker in.
Lubricate the treadmill band.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt tension.
4) Reset the overload button with
the On /Off switch at „0" and
lubricate the treadmill band.
5) Plug the machine into an
earthed mains socket.
Connect the wire well between top controller
and bottom controller
Check the voltage. Check whether the
controller has an abnormal smell. Check
whether the motor cable is properly
connected and reconnect the motor cable.
Reconnect the cable or replace the speed
sensor.
Check whether the incline motor AC cable is
correctly connected. Check whether the
motor connection cable is broken or open-
circuit, and replace the connection cable or
incline motor. Re-calibrate the motor.
Lubricate the belt. Check the controller and
the motor.
Change the controller.
12