First Use; Checking The Heater And Package Contents; Preparing For Use; Operation - Easy Home BLT-999T-3-1 Manual Del Usuario

First use

Checking the heater and package contents

NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a
sharp knife or other pointed object, you may quickly damage
the heater.
− For this reason, be very careful when opening the
packaging.
1. Take the heater out of the packaging and check whether it or any of the
individual parts are damaged. If this is the case, do not use the heater.
Contact the manufacturer via the service address indicated on the warranty
card.
2. Check to make sure that all components and accessories have been
received (see fig. A and B).

Preparing for use

1. Make sure to remove any small bits of plastic or other packaging that may
be lodged in between the heating element and air vents
2. Place the heater on a flat, dry and heat-resistant surface.
3. Make sure the heating element/air vent slots are not covered and that there
is adequate ventilation in the room.
The heater may emit a faint smell when it is first heating up. This is entirely
safe and harmless.

Operation

The heater is fitted with an automatic safety thermal cut-off
system to prevent it from overheating.
1. Turn on the heater by setting the ON/OFF switch
(see fig. C).
2. For low heat, set the low heat (I) switch
3. For high heat, also set the high heat (II) switch
Both low and high heat switches need to be in their respective "on"
positions for high heat output.
to the ON position
8
9 to the "I" position.
to the "II" position.
10
First use
.
3
13