Bosch GWX18V-13C Instrucciones De Funcionamiento Y Seguridad página 5

General Power Tool Safety Warnings
modified batteries may exhibit unpredict-
able behaviour resulting in fire, explosion
or risk of injury.
Do not expose a battery pack or tool to
fire or excessive temperature. Exposure
to fire or temperature above 265 °F may
cause explosion.
Follow all charging instructions and do
not charge the battery pack or tool out-
side the temperature range specified in
the instructions. Charging improperly
or at temperatures outside the specified
range may damage the battery and in-
crease the risk of fire.
Power Tool-Specific Safety Warnings
Safety Warnings Common
for Grinding, Sanding, Wire
Brushing, and Abrasive
Cutting-Off Operations
This power tool is intended to function
as a grinder, sander, wire brush or cut-off
tool. Read all safety warnings, instruc-
tions, illustrations and specifications
provided with this power tool. Failure to
follow all instructions listed below may re-
sult in electric shock, fire and/or serious
injury.
Operations such as polishing are not rec-
ommended to be performed with this
power tool. Operations for which the
power tool was not designed may create a
hazard and cause personal injury.
Do not use accessories which are not spe-
cifically designed and recommended by
the tool manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
The rated speed of the accessory must
be at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their rated speed can
break and fly apart.
The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool. In-
Service
Have your power tool serviced by a quali-
fied repair person using only identical
replacement parts. This will ensure that
the safety of the power tool is maintained.
Never service damaged battery packs.
Service of battery packs should only be
performed by the manufacturer or autho-
rized service providers.
correctly sized accessories cannot be ad-
equately guarded or controlled.
Threaded mounting of accessories must
match the grinder spindle thread. For ac-
cessories mounted by flanges, the arbour
hole of the accessory must fit the locat-
ing diameter of the flange. Accessories
that do not match the mounting hardware
of the power tool will run out of balance,
vibrate excessively and may cause loss of
control.
Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install
an undamaged accessory. After inspect-
ing and installing an accessory, posi-
tion yourself and bystanders away from
the plane of the rotating accessory and
run the power tool at maximum no-load
speed for one minute. Damaged accesso-
ries will normally break apart during this
test time.
Wear personal protective equipment. De-
pending on application, use face shield,
safety goggles or safety glasses. As ap-
propriate, wear dust mask, hearing pro-
tectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments. The eye protection
-5-