WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spackling
compounds, or plaster are subject to accelerated wear and
possible premature failure because the fiberglass chips and
grindings are highly abrasive to bearings, brushes, commuta-
tors, etc. Consequently, we do not recommended using this
product for extended work on these types of materials. How-
ever, if you do work with any of these materials, it is extremely
important to clean the product using compressed air.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 10
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
MAINTENANCE
This product has a Three-year Limited Warranty.
For Warranty details go to www.ryobitools.com
LUBRICATION
All of the bearings in this product are lubricated with a suf-
ficient amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.
POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service center in order to
avoid a safety hazard.
CHUCK REMOVAL
See Figure 7, page 11.
The chuck may be removed and replaced with a new one.
Unplug the drill.
Insert a 5/16 in. or larger hex key into the chuck of the
drill and tighten the chuck jaws securely.
Tap sharply with a mallet in a counterclockwise direction.
This will loosen the chuck on the spindle. It can now be
unscrewed by hand.
Open the chuck jaws and remove the hex key.
TO RETIGHTEN A LOOSE CHUCK
See Figure 8, page 11.
The chuck may become loose on the spindle and develop
a wobble.
To tighten:
Unplug the drill.
Open the chuck jaws.
Insert a 5/16 in or larger hex key into the chuck and tighten
chuck jaws securely. Tap the hex key sharply with a mallet
in a clockwise direction. This will tighten the chuck on the
spindle.
Open the chuck jaws and remove the hex key.
9 − English