Pro-Lift PL3300 Instrucciones De Funcionamiento Y Manual De Piezas página 3

WARNING
!
• Study, understand, and follow all instructions
before operating the device.
• Do not exceed rated capacity.
• Use only on hard, level surface capable of
supporting the load.
• Center load on saddle.
• Use as an identical pair only.
• Stands are not to be used to simultaneously
support both ends of a vehicle.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
WARNING
!
To avoid crushing and related injuries:
NEVER work on, under or around a load
supported only by a hydraulic jack. ALWAYS use
an identical pair of adequately rated jack stands.
WARNING
!
Failure to assure that that both jack stands, used as an
identical pair, are fully loaded can result in death, serious
injury or property damage. Make sure that both jack
stands, used as a pair, are fully loaded before working
under a vehicle supported by this pair of jack stands.
WARNING
!
Working under a load supported by a temporary lifting
device may result in death, serious injury, or property
damage. Minimize the amount of time that you are
exposed under a load supported by a temporary lifting
device by setting the height and pinning the jack stands to
their desired heights before going under the load to use
the identical pair of jack stands to support the front or rear
end of the vehicle.
OPERATION
Supporting a load
! WARNING: Support areas of vehicle specified
by vehicle manufacturer. Use ONLY on vehicles
whose support points are compatible with saddle
of jack stand. Incompatibility may result in
structural damage to vehicle and/or jack stand.
1. Adjust height by pulling up on ratchet bar.
2. The weight of locking handle should secure the
ratchet bar in desired position. To confirm, push
down on the locking handle. Ensure ratchet and
locking pawl are secure before loading.
3. Insert the mobility pin after pawl and ratchet are
engaged.
4. Carefully position jack stands so that load is centered
on stand's saddle.
5. Lower the vehicle onto the stands.
6. Ensure vehicle is secure before working on, around
or under. Chock all unlifted wheels in both directions
to prevent inadvertent movement.
Removing Jack Stands
!
WARNING: Clear all tools and personnel before
lowering load.
1. With suitable jack, raise vehicle clear of stands.
2. Remove the mobility pin.
3. Raise locking handle and allow ratchet bar to
descend to lowest position.
4. Remove jack stands, then lower vehicle with lifting
device.
MAINTENANCE
Periodically inspect both stands. Ensure all parts move
freely. Do not apply oil or grease to any portion of this
product. If rust appears, sand affected area and cover
with suitable utility paint. Please note that there are
no replacement parts applicable to this equipment.
Replacement stands must be purchased as an
identical pair.
Storage
Store stands in upright position and in a clean, dry
area.
3