Panasonic CS-UE9RKE Manual Del Usuario página 6

How to use
MODE
To select operation mode
AUTO mode - For your convenience
• During operation mode selection the power
indicator blinks.
• Unit selects operation mode every 10 minutes
according to setting temperature and room
temperature.
HEAT mode - To enjoy warm air
• Unit takes a while to warm up. The power
indicator blinks during this operation.
COOL mode - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
To switch between
POWERFUL/
QUIET
powerful & quiet
POWERFUL QUIET
POWERFUL: To reach temperature quickly
POWERFUL
• This operation stops automatically after
20 minutes.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
To adjust horizontal
airfl ow direction
• Manually
6
NORMAL
Auto OFF/ON button
adjustable.
Remote control
display
AUTO
FAN
SPEED
HEAT
AIR
COOL
SWING
DRY
OFF/ON OFF/ON
MODE
TEMP TEMP
AIR SWING
POWERFUL/ /
QUIET FAN SPEED
TIMER TIMER
ON ON SET SET
1 1 2 2 3 3
OFF OFF CANCEL CANCEL
AC RC
SET CHECK CLOCK CHECK CLOCK RESET
FAN SPEED
To select fan speed
(
Remote control display
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
• To have low noise priority operation, select the
lowest fan speed ( ).
Use when remote control is misplaced or a
malfunction occurs. Raise the front panel:
• To use in AUTO mode, press the button once.
• To use in COOL mode, press and hold the button
until 1 beep is heard, then release.
• To use in HEAT mode, press and hold the button
until 1 beep is heard, then release. And press
again until 2 beeps, then release.
• Press the button again to turn off.
Remote control receiver
and indicator
(Green)
POWER
(Orange)
TIMER
(Orange)
POWERFUL
(Orange)
QUIET
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
)