Publicidad
Idiomas disponibles
Idiomas disponibles
EN
7. LCD Display Guide
Warning
1.Please cut the power supply of the bike before you disconnect the display. Otherwise, it
may cause permanent damage to the display.
2.Don't overtighten the screws when you install the display. Normally, the display can be
mounted firmly on the handlebar with 0.2N.m torque. Overtightening it will cause
permanent damage to the display.
3.Don't soak the display in the water or clean it with water spray. Use a soft and damp cloth
to wipe it slightly. Do not clean it with detergent, alcohol, gasoline, acetone, or other
corrosive/volatile solvents.
4.When you ride the bike on rainy days, please clog the USB port of the display to protect it
from water and rain. Don't plug any devices in the USB port in the rain.
5.Please follow the local regulations about the disposal of the display.
6.Users will be responsible for the damage caused by improper or incorrect installation.
Diagram
1
1
Screen
Screws for Adjusting Support Angle(M3*6)
3
Supports
4
Rubber Clog of USB Port
6
3
10
2
3
4
2
Shell
Screws for Fixing the Support(M3*12)
5
1
1
ON/OFF
2
UP
2
DOWN
3
5
6
Publicidad
