Senix PSRX2-M2 Manual Del Operador página 15

2. Connect the charger to a power supply, the light
indicator of the charger turns red.
3. Align the raised ribs of the battery pack with the slot in
the charger.
4. Insert the battery pack into the charger, the light
indicator of the charger turns green and it flashes.
5. The charger will communicate with the battery pack to
evaluate the condition of the battery pack.
6. It is fully charged that the four lights of the battery turn
on. Disconnect the power supply from the charger.
Remove battery pack from the charger.
CHARGING INDICATOR
Press the light button on the battery pack to check whether
it needs to charge.
Light Button
Lights
Lighted Off Blinking
WWW.SENIXTOOLS.COM
Indicator
Status
The battery is at full
capacity.
The battery is at 75%
capacity.
The battery is at 50%
capacity and requires
charging.
The battery is at 25%
capacity and requires
charging soon.
The battery is less
than 5% capacity
and requires charging
immediately.
WARNING:
Malfunctions may occur when the four lights
blinking in turns.
OVERHEAT PROTECTION
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the power tool/battery cool
before turning the tool on again.
OVERDISCHARGE PROTECTION
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the tool
and charge the battery.
15 - EN