essentiel b ESLHP10-2b Instrucciones De Uso página 45

PAUSING THE MACHINE
Keep the START/PAUSE button pressed

for about 2 seconds (the name of the
programme and the residual time display
will flash, showing that the machine is
paused).
Press the START/PAUSE button again to

re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
To cancel the programme, turn the

programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
DELAY START button
This button allows to delay the start of the

programme from 30 minutes (1 hour on
some models) to 24 hours in 30 minutes
intervals (1 hour on some models).The
delay selected is shown on the display.
After pressing the START/PAUSE button

the time showed decrease minute after
minute.
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
TIME CYCLE SELECTION button
It's possible transform a cycle from

automatic to programmed, up to 3
minutes after the start of the cycle.
The progressive pressure increases the

time in 10 minute intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
In case of incompatibility, all indicator

lights flash quickly for 3 times.
HYGIENE REFRESH button
HYGIENE REFRESH is the perfect cycle

to use if you want to remove bad smells,
germs, spores and bacteria in a natural
way and gently
guaranteeing the best result in a very
short time.
If you want to select this option, press the

HYGIENE REFRESH button once. It is
available only during program selection.
This option
selected with a dedicated one.
If you want to deselect the HYGIENE

REFRESH option, press the HYGIENE
REFRESH button. When you deselect the
option, the machine will show again the
original program name.
DRYING SELECTION button
This button allows to set the desired

dryness level editable option up to 3
minutes after the starting of the cycle:
Ready to Iron: it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger: to get garment ready to
be hang.
Dry wardrobe: for laundry that can be
directly stored.
Extra-dry: to get completely dry
garments, ideal for full load.
45
refreshes clothes
overwrites the program