Publicidad
Idiomas disponibles
Idiomas disponibles
N. Mattress
O. Car seat adapters
ASSEMBLING AND USE:
1. Before assembling, make sure that nothing is missing
2. Place the frame on a flat surface and unlock the frame lock button (as shown at picture 1-2).
3. Grab the handle and pull it upwards to unfold the frame (as shown at picture 3-4).
4. To install the rear axle with brake, the frame should be positioned as shown at picture 4 and insert
the plastic holes at both ends of the brake (as shown at picture 5) into the metal tube of the frame
until you hear a click (as shown at picture 6)
5. Install the rear wheels by inserting them into the holes on the rear axle until you hear a click, then
you are sure that the wheels are properly and securely assembed (as shown at picture 7-8).
6. To install the front wheels, insert them into the holes in the front of the frame until you hear a click,
then you can be sure that the wheels are properly and securely assembled (as shown at picture
9-10)
7. To remove the front wheels, press the quick release button (as shown at picture. 9b)
8. To remove the rear wheels, press the lock button and pull the wheels out of the holes (as shown at
picture 7b)
9. To embed the carrycot, put it on the stroller frame as shown at picture 11
10. Place the carrycot on a flat surface. Press the footrest adjustment buttons (as shown at picture 11) to
unfold the carrycot. Before installing the carrycot on the stroller frame, attach the Velcro fasteners
to the metal rod on the bottom of the carrycot and leave it unfolded. When mounting the gondola
on the trolley frame, attach it to the designated holes on both sides of the stroller frame until a
characteristic click
11. The stroller is ready for use as a deep gondola.
STROLLER:
12. If you want to use the stroller as a pushchair, install the bumper by inserting its ends into the plastic
tubes in the center of the carrycot (as shown at picture 12-13) until you hear a click
13. Adjust the seat by pressing the large, round buttons on the sides of the carrycot (as shown at
picture 14)
14. To adjust the footrest, fasten the buckles at the ends of the footrest adjustment straps on the
bottom right and left of the carrycot. The footrest will lift up (as shown at picture 15-16).
15. Repeat with the next pair of clamps in the opposite direction
16. Unfasten the Velcro fasteners on the metal bar on the underside of the carrycot. Slide the metal
bar towards the footrest, thus creating the seat of the pushchair.
17. Adjust the backrest to the child's needs by loosening or tightening the buckle on the backrest of the
stroller (as shown at picture 17-18). To do this, press the button on the belt buckle and pull it up or
down
USE OF THE BRAKE:
This stroller is equipped with a foot parking brake on the rear axle. Press the brake pedal downwards (as
shown at picture 19a) so that the brake is activated. Unlocking takes place after lifting the pedal up (as
8
EN
Publicidad
