Publicidad
SURFACE INSTALLATION AND ELECTRICAL WIRING
Note: A Surface Mount Kit (refer to the cabinet's instructions, sold separately) is required for the following instructions.
1. Prepare the electrical rough-in as shown below.
2. Remove the two #6-32 screws holding the electrical enclosure cover in place. Set the cover and screws aside in a safe place.
3. With the electrical cover removed, feed the field wire through the field wire strain relief at the back of the electrical enclosure and
secure.
4. Mount the cabinet in place following the steps provided in the cabinet's or Surface Mount Kits instructions.
5. Make the electrical connection according to the electrical diagram on page 9.
Note: Leaving too much field wire in the enclosure could prevent it from closing properly and may cause damage to the internal
components.
6. Replace the electrical cover utilizing the two #6-32 screws removed in Step 2.
Cabinet Width + 1/2"
1
Ø 1-1/4" (32mm)
12" (305 mm)
1-1/4" (32mm)
30" Tall Cabinet = 16-1/2" (419 mm)
36" Tall Cabinet = 22-1/2" (572 mm)
40" Tall Cabinet = 25-7/8 (657 mm)
wiring access
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
www.robern.com
800.877.2376
C L
2
11
3
Part no. 209-1400 17-NOV-2022
Tenor Light
C L
Publicidad
