KRESS Mission MARCONI KA0211 Manual De Instrucciones página 7

Assembly
WARNING: Before assembly, make sure machine is turned off.
The installation of node
1. Connect the node with the wire (Fig. A)
2. Install node
Note: Please open the cover of machine before operation
Put node into the slot as picture has showed. (Fig. B).
3. Connect wire with the board (Fig. C1, C2 ).
1) As picture has showed, connect end of the wire with the mainboard.
2) Organize the wire and then put the mainboard into the mainboard slot, and fix it with the pressure plates and
screws(come with the machine).
3) Close the cover to complete the operation.
The installation of gateway at home
1. Assemble the AC adapter and cable (for AC adapter) to power the gateway. A few seconds later, the indicator
of network,gateway/node and power will individually turn red, green and blue .Use the cable (for gateway) to
connect your router and gateway(Fig. D). The network indicator will turn green in 10 seconds. At this time , the
three lights will be red ,green and blue from left to right. (Fig. E)
2. Employ the sharp object to press the reset button. Then the lights separately turn multi-colors.(Fig.F,G)
The connection between gateway and mower
1) For LED display
Turn your lawn mower on then input the correct PIN code of user. Press
"nrc" will be displayed on the screen. Afterwards press
J has showed and the lights on gateway all turn green after about one minute which means that the gateway and
lawn mower have been connected successfully (Fig. K).
2) For LCD display
Turn your lawn mower on then input the correct PIN code of user. Choose
Marconi", press to confirm. Then screen will display "Press "OK" to start pairing Marconi - Gateway" ,press
to confirm. Finally, the screen displays "Pairing successful!" and the lights on gateway turn green which means the
gateway and lawn mower have been connected successfully (Fig. L, M,N,O,P)
Troubleshooting
Make sure your Marconi module is securely installed and follow the actions below if your Marconi does not operate
correctly.
If these do not identify and correct the problem, contact your dealer.
Symptom
Network indicator on
gateway turns red
The indicator of Gateway /
node turns red
Power indicator turns
red
Note: if despite acting as above the machine still not work properly, you should try to re start it and re-pair following
manual instruction
Cause
The cable is not connected
properly.
the lawn mower is not turned on or
the module is not properly plugged.
Lawn mower and gateway are not
paired correctly.
Gateway is not connected to the
network.
for three seconds. Then press
. (Fig. H ,I).The screen will display the interface ,as figure
and press
Make sure it is properly connected on both
sides.
Turn the lawn mower on or plug the module
properly.
Make sure Gateway and lawn mower are
paired correctly.
Under the premise of tight connection
between router and Internet, make sure the
gateway is connected with router normally.
and
. Then select "Setup
Action
7
En