Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions
See parts list table and Figure-1 for names and identification of the
components and hardware.
Tools Required (not included): 5mm Allen Wrench, 6mm Allen Wrench,
Adjustable Wrench
Remove components from the box and spread them out to make certain that
all parts and hardware are included and are not damaged from shipment.
Complete the assembly before discarding the box.
1. Begin by inserting a Cylinder Nut (I) into the hole at the bottom of a Vertical
Leg (B). Orient the hole in the Cylinder Nut facing up as shown in Figure-2.
2. Place a Small Screw (J) through the Horizontal Foot (A) as shown in
Figure-3 so that the head of the screw is inside the tube. A 5mm Allen
Wrench (not included) is useful to keep the screw steady during alignment.
3. Tighten the Small Screw firmly into the Cylinder Nut with the 5mm Allen
Wrench as in Figure-4.
4. Repeat Steps 1 and 2 for the other Vertical Leg.
5. Next fasten the two Vertical Legs together at the hinge point with a Large
Screw (F). Use a Large Washer (G) and a Large Nut (H) to complete the
assembly as shown in Figure-5. The Large Screw is tightened using a 6mm
Allen Wrench (not included) while a standard adjustable wrench holds the
nut steady.
6. Identify the slotted hole at one end of the Internal Extension Arm (D). This
is the top front side that will align with the product labels. Insert this Arm
(D) into the short Leg so that the small hole is facing to the back hinge as
shown in Figure-6.
7. Fasten the Height Adjustment Handle (E) into the pre-drilled hole on the
side of the hinge also seen in Figure-6.
8. Spread the stand legs open and rest it on the ground. Attach the Roller
Head Assembly (C) using a 5mm Small Screw (J) Small Washer (K) and
Small Nut (L) as shown in Figure-7.
Figure 5
Figure 6
5
Figure 2
Figure 3
Figure 4
Figure 7
Publicidad
