Num'axes PIE1046 Manual De Instrucciones página 21

If a signal bar pops up on the screen, it means the camera has automatically connected to the network. By then, you
only need to fill in the phone numbers and e-mail addresses in the "Recipients" setting to receive photos/videos
upon motion triggers.
If the message "SIM Auto setup failed, enter setups manually" pops up on the screen, please switch the "SIM setup"
from "Auto setup" to "Manual setup" mode, then enter the MMS and 4G setups in "Manual Setup".
NOTE: This camera can send photos to 4 cell phones and 4 e-mail addresses. It's set to send photos to cell phones
via MMS, and photos/videos to e-mail addresses via SMTP (data). If you prefer a more personalized way of
sending, please configure the settings accordingly.
9. Operation list
9.1. Photo/video playback on the LCD screen
− Slide the switch to the "SETUP" position.
− Press "" to enter playback, then press "" and "" for selection.
− Press "OK" to play photo/video.
− Press "" again to exit.
9.2. Delete files
− Slide the switch to the "SETUP" position.
− Press "" to enter playback, then press "" and "" for selection.
− Press the "MENU" button then select "Delete" and press "OK".
− Select "One" (delete the selected photo/video) or "All" (delete all photos/videos) then press "OK".
− If your selected "One", "Delete This File?" will appear on the screen, select "Yes" or "No" then press "OK".
− If you selected "All", "Delete all files?" will appear on the screen, select "Yes" or "No" then press "OK".
− Press "MENU" to exit.
9.3. Format SD card
− Slide the switch to the "SETUP" position.
− Press "" to enter playback.
− Press the "MENU" button then select "Format" and press "OK".
− Select "Yes" or "No". If you selected "Yes", "Are you really sure?" will appear on the screen, select "Yes" or
"No" then press "OK".
− Press "MENU" to exit.
9.4. Auto power off
In "SETUP" mode, the camera will automatically power off if you don't press the keypad for more than 3 minutes.
Slide the switch to "OFF" then back to "SETUP'" if you want to do some further configuration.
NOTE: the camera stays in "SETUP" mode if the camera is in Menu configuration pages.
9.5. Operation menu
Slide the switch to the "SETUP" position then press "MENU" once to enter the camera setting menu.
You can navigate the setting interface by pressing "", "", "" or "". Press "OK" for selection, press "MENU" to
exit to the previous page, and press "MENU" to switch alpha/digits/symbols.
NOTE: For some settings, you need to press "MENU" to save and exit the configuration after pressing "OK" to confirm
(Camera ID, PIR interval, Time Lapse, Working timer, Password).
PIE1046 - Indice A –Septembre 2020 21/76