Publicidad
Idiomas disponibles
Idiomas disponibles
PICTURE 06
2.2.3
Cap Positioning
PICTURE 07
The Cap is used to follow the process and also to add more
product to be processed.
To remove the Cap, just turn in clockwise so that it releases,
pulling it up.
3. Operation
3.1 Starting the appliance
- Connect the appliance to a power outlet.
- Position the General Switch to "I".
- To switch on the appliance, just press "I"(No. 01 Picture
08).
- To switch off the appliance, only press "O" button (No. 02
Picture 08).
- If the lid is removed during the operation, for safety rea-
sons, the machine will be turned off automatically. In this
case, place the lid in the correct position, press "O" button
and after that turn it off, pressing the "I" button
PICTURE 08
02
3.2 Operation procedures
Before using the equipment, all the parts that are in contact
with the products to be processed should be washed with
water and mild detergent (see item 3.4 Cleaning).
Check if the appliance is firm in its workplace.
Remove the Jug Lid with the Cap.
With the equipment turned off, fill the Jug with liquid
products and after that products with more consistency.
Place the Lid with the upper lid as described before in Items
2.2. and 2.2.3 and switch on the appliance.
The processing time changes for each product. Solid
products should not be processed without a liquid,
LID SENSOR
because overheating may occur and therefore damage the
Jug seal.
LID SENSOR
Never switch on the Appliance when empty, because it
BASE
can cause irreparable damages.
3.3 Safety System
This appliance features a safety system to guarantee
the safety of the operator. The operation of the equipment
must follow the item 03. Other procedures are unsafe and
must not be used.
3.3.1 Reset System
For the safety of the operator, the appliance features a
safety system to avoid involuntary restart, even in case of
the power shortage.
3.4 Cleaning and Sanitizing
The equipment must be completely clean and sanitized
- Before being used for the first time:
- After the everyday operation;
- When it hasn´t been used for a long time;
- Before using it after some time of inactivity.
Some parts of the equipment can be removed for the
cleaning:
- Jug No. 02
- Lid No. 01
- Cap No. 10
Wash all parts with water and mild soap.
- To wash inside the Jug, fill it up to half of its capacity with
water and add a bit of mild detergent.
- Put the lid and switch on the Blender for 30 seconds.
- Remove the liquid and rinse it.
- If necessary, use a nylon brush to help removing materials
that are difficult to be removed.
Do not use direct water jet to the equipment.
01
3.5 Cautions with Stainless Steels
The Stainless Steel may present rust signs, which ARE
ALWAYS CAUSED BY EXTERNAL AGENTS, especially when
the cleaning or sanitization is not constant and appropriate.
The Stainless Steel resistance towards corrosion is mainly
due to the presence of chrome, which in contact with
oxygen allows the formation of a very thin protective coat.
This protective coat is formed through the whole surface of
the steel, blocking the action of external corrosive agents.
When the protective coat is broken, the corrosion process
begins, being possible to avoid it by means of constant and
adequate cleaning.
Cleaning must always be done immediately after using the
equipment. For purpose, use water, mild soap or detergent,
and clean the equipment with a soft cloth or a nylon sponge.
Then rinse it with plain running water, and dry immediately
13
Publicidad
