Tripp-Lite AGPD7898 Manual Del Propietário página 9

Features
continued
Circuit Breakers (Select Models): If the connected
equipment load on a load bank exceeds the Maximum Load
Rating of the load bank, the circuit breaker will trip. Disconnect
excess equipment and switch breaker to the on position to reset
the breaker. Models with multiple outlet banks have a circuit
breaker for each bank. Circuit breakers are only used to protect
output load banks.
Cord Retention Bracket (Select Models): Provides secure
attachment points for connected equipment cords.
C14 Plug Sleeve: (Optional) Use the included C14 plastic
sleeves to secure plugs to C13 receptacles. Attach the sleeve to
the plug making sure that the pull tabs remain outside the plug
and that the fit is secure. To unplug equipment properly, use the
pull tabs to remove the plug and sleeve from the receptacle.
C20 Plug Sleeve: (Optional) Use the included C20 plastic
sleeves to secure plugs to C19 receptacles. Attach the sleeve to
the plug making sure that the pull tabs remain outside the plug
and that the fit is secure. To unplug equipment properly, use the
pull tabs to remove the plug and sleeve from the receptacle.
Mounting Brackets: Use these brackets to mount the PDU.
PDUMVROTATEBRKT Mounting Accessory: Use these
V-shaped brackets to mount the PDU with its outlets facing the
rear of the rack.
SNMP Reset Button: Press the reset button A
for 3 seconds
to reboot the PDU's network card. Rebooting the network card
will not erase network settings or interrupt AC power. The reset
A
button is recessed; use a suitable tool to press it.
ACCY Port: The port is reserved for future expansion.
9
13-11-194-933093.indb 9 12/5/2013 5:22:05 PM