Descargar Imprimir esta página

COZY W255G Instrucciones De Instalación Y Funcionamiento página 20

Publicidad

Idiomas disponibles

Idiomas disponibles

MODEL WFF81-C OPTIONAL FAN KIT - ( INSTALLATION INSTRUCTIONS )
NOTE: This fan kit is to be installed after installation of the wall
furnace and with the wall furnace front panel in place.
STEP 1.
This
appliance,
electrically grounded in accordance with local
codes, or in the absence of local codes, with
the latest edition of the National Electric Code,
ANSI/NFPA No. 70. In Canada, see the current
Canadian Electrical Code CSA C22.1.
STEP 2.
Set fan kit on top of the wall furnace front panel.
Using the back top edge of the fan kit cabinet as
a guide, mark a horizontal line across the wall.
Mark a small vertical line which aligns with the slot
located toward the rear of the fan kit casing.
STEP 3.
Using the four one inch screws provided,
secure the wall mounting bracket to wall 1/8" below
the horizontal line. Fan attachment bracket must be
up and threaded nut sert aligned with the small
vertical line.
Note: Anchors (not provided) may be required.
STEP 4.
Remove junction box and connect 115v power
supply in accordance with the wiring diagram.
Replace junction box.
STEP 5.
Set fan kit on top of wall furnace front panel. Slot
should align with the nut sert. Secure fan kit to
wall mounting bracket with thumb screw provided.
FIG. 16
WHITE
L2
WHITE
115 VAC 60 HZ - LESS THAN 12 AMPS. IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THIS APPLIANCE MUST BE
REPLACED, IT MUST BE REPLACED WITH TYPE THERMOPLASTIC 105 DEGREE C WIRE OR ITS EQUIVALENT.
1017754-A
when
installed,
must
WFF81 - C
BLACK
MOTOR
FIG. 15
JUNCTION
BOX
be
THREADED
NUT SERT
FAN
ATTACHMENT
BRACKET
WALL
MOUNTING
BRACKET
ONE INCH
SCREW (x4)
FAN KIT
WALL FURNACE
FRONT PANEL
WIRING SCHEMATIC
GROUND
L2 WHITE
115 VAC
WHITE
BLACK
BLACK
GREEN GROUND WIRE
Page 20
WIRING
DIAGRAM
THUMB
SCREW
SLOT
L1 BLACK
115 VAC
BLACK
FAN SWITCH
BLACK
L1
BLACK

Publicidad

loading