Publicidad
Idiomas disponibles
Idiomas disponibles
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
WARNING: do not use a pipe carrying
combustible material as the ground source.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
2
LUBRICATION
DO NOT attempt to start the engine without filling the
engine crankcase with the proper amount and type of
oil. Use SAE 10W-30 oil.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
Your generator has been shipped from the factory without
oil in the engine crankcase. Operating the unit without oil
can damage the engine and lose the warranty.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
Fill the engine according to the engine manual. In this
engine the plastic plug of the engine crankcase is the oil
fill and check plug.Fill with oil and check the level using
the marks settings in the dipstick.
3
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
LOW OIL SENSOR
The engine is equipped with an oil sensor. If the oil level
becomes lower than required, the sensor will activate
a warning device and stop the engine (see the
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
accompanying engine manual for more information).
If the generator turns off and the oil level is within
specifications, check that the generator is not placed at
an angle that forces the oil level to change. Place the
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
generator in an even area to correct this problem. If the
engine doesn't start, the oil level could not be enough
to shut off the automatic "low oil" swith. Make sure the
oil cap is in the correct level.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
4
FUEL
Fill the tank with unleaded fuel, clean and new. You can
use regular-grade fuel as long as it has a high octane
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
value (at least 85 octane). Always use a fuel additive.
A fuel additive will minimize the development of fuel
gum deposits during storage. The fuel additive can be
added to the fuel int the gas tank or put toguether to the
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
fuel in a storage container. The fuel and engine smoke
are flammable and potentially explosive. Use a suitable
procedure to store and handle fuel. Always have ABC
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
fire extinguisher nearby.
CAUTION
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
Do not overfill the tank.
Keep maximum fuel level
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
to ¼ inch below the top of
the tank. This will allow for
expansion during warm weather, and
so, avoiding spillage.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
WARNING
ELECTRIC EXTENSIONS OR CORDS
1
All generator loads will be connected from the control
panel with extensions or cords with 3-prong grounded
plug for connection to120 volts outlet and 4-prong
grounded plug for connection to 120/240 volts outlets.
2
See Table 3 for select the minimum cable gauge of
extensions or cords in agreement with the necessities
of the loads.
3
When the load increases must be used a cable extension
of greater size. Using extensions of inadequate size it is
in where can result in serious problems with the voltage,
reducing the electric energy applied to the tools and
causing damage on them.
4
As far as smaller is the number of the wire gauge greater
is the conduction capacity, an example is that A wire
gauge 14 for example can lead a current higher than a
wire gauge16.
5
When several extensions are connected it is a must to
review that each extension is of the minimum gauge
required.
6
If you need to use an extension with outlets to connect
more than one electric tool, sum the amperes marked in
the nameplates of each tool to determine the minimum
cord gauge you need to use.
7
The extensions for 120 volts are made of 3 cables where
the green cable is the grounding one, the white cable is
the neutral and the black cable is the hot wire.
5-20P
The extensions for exits of 120/240 are made of 4 cables
8
where the green cable is the grounding one, the white
cable is the neutral and the black and red cables are
the hot wires.
L14-30P
5
Publicidad
