EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
• Provide adequate ventilation for toxic exhaust
gases and cooling air flow.
• Do not start or run the generator in an enclosed
area, even if doors or windows are open.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
• Engines operation produces carbon monoxide, an
odorless, colorless, poison gas.
• Breathing carbon monoxide can cause nausea, fainting
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
or death.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
This unit has been pretested and adjusted to handle its
full capacity. When starting the generator, disconnect
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
all loads. Apply load only after the generator is running.
Voltage is regulated via the engine speed adjusted al the
factory for correct output. Readjusting will void warranty.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
When applying a load, do not exceed the
maximum wattage rating of the generator
when using one or more receptacles.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
Also, do not exceed the amperage rating of any
receptacle.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
SHUTTING THE GENERATOR OFF
1
Remove entire electrical load.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
2
Let the engine run for a few minutes with no load.
3
Move the engine switch to the "OFF" position.(turn the
key switch to "OFF" on the electrical start models).
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
4
Do not leave the generator until it has been completely
stopped.
5
Close the fuel shut off valve if the engine is to be put in
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
storage or transported.
6
If cover is used, do not install it untill the generator is
cool.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
INITIAL START PROCEDURE
Controlled initial start helps insurance of proper engine
and generator operation. Follow engine start procedure
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
outlined in engine manual.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
Do not apply a heavy electrical load during
start period (the first two to three hours of
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
operation).
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
ATTENTION: Disconnect all plugs from the panel, and
the cable of the spark plug if the motor is of electrical
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
starting, before any inspection for maintenance.
1
Before each use, review the general conditions for the
generator, review that all the pieces are complete, review
if there are damaged cables or some other condition that
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
DANGER
APPLYING LOAD
CAUTION
CAUTION
MAINTENANCE
can affect that the generator operates on safe way. If a
strange noise is listened to or some abnormal vibration,
turn off the generator immediately. Be sure to fix the
problem before giving the generator more use. Do not
use the equipment damaged.
2
Periodically inspect all the screws and bolts to check
they are in place and tight.
3
Keep this equipment in a clean and dry place.
For the best maintenance of the engine and any other
4
problem, read the engine owner's manual.
5
After the engine has become cool, remove the excessive
gasoline and store it in a container, safe and approved
for that purpose.
6
After the first 20 hours of use of the generator drain and
replace the oil of the engine, after that the oil must be
changed every 100 working hours
HEAT SHIELD:
Inspect to ensure that all heat shields and heat deflectors
are intact and in place. Removing of these parts could
cause serious damage to the unit.
ENGINE: Carburetor Icing
During the winter months, rare atmospheric conditions
could cause an icing condition in the carburetor. If it
happens, the engine may run rough, loose power, and
may stall. Call Product Service for more information.
NOTE: Refer to the engine manufacturer's manual for
service and maintenance of the engine.
QUICK STARTING TIPS FOR UNITS THAT
HAVE BEEN SITTING FOR A WHILE
If your unit has not been used for a long period of time
and it is hard to start it, try to do some of these easy
steps before calling the customers hotline.
1
Check the oil level.
2
Replace the old fuel.
3
Change the spark plug.
4
Check the fuel lines. Make sure the fuel valve is open.
5
Check all generator parts for integrity
6
Clean the carburetor. (See engine manual for service
centers)
SERVICE AND STORAGE
INFREQUENT SERVICE
If the unit is used infrequently, difficult starting may result,
to eliminate hard starting, run the generator at least 30
minutes every 15 days. Also, if the unit will not be used
for some time, it is a good idea to drain the fuel from the
carburetor and gas tank.
LONG TERM STORAGE
When the generator set is not being operated or is being
stored more than one month, follow these instructions:
1
Replenish engine oil to upper level.
2
Drain gasoline from fuel tank line and carburetor.
3
Pour about one teaspoon of engine oil through the spark
plug hole, pull the recoil starter several times and replace
the plug. Then pull the starter until you feel piston is on
its compression stroke and leave it in that position. This
closes both the intake and exhaust valves to prevent the
inside of cylinder from rusting.
4
Cover the unit and store in a clean, dry place that is well
ventilated away from open flame or sparks.
NOTE: We recommend always using a fuel stabilizer.
A fuel stabilizer will minimize the formation of fuel gum
deposits during storage. The fuel stabilizer can be added
to the gasoline in the fuel tank, or into the gasoline in a
storage container.
7