Descargar Imprimir esta página

Rupes SL42AES Traducción De Manual De Instrucciones Original página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
INFORMATOIN NOISE / MEAN ACCELERATION VALUE
The tools are suppressed in accordance for the prevention and elimination of radio
disturbances measured in accordance with standard: EN 60745
Sound pressure level / Sound power level
L PA
L WA
dB(A)
SL42AES
86
97
DANGER The indicate measurements refer to new power tools.
Daily usa causes the noise and vibration values to change.
Displayed emission values are comparative and are to be employed for
a provisional assessment of the operator's risk exposure during the work period.
Appropriate evaluation of work period must also include tool's idle and stop
periods. These emission values represent the tool's main applications.
If the tool is used for other applications, with other accessories, or if it does not
undergo regular maintenance, emission values can significantly increase
during operations.
Use hearing protection!
PARTS OF THE TOOL
1 - Technical data identification label
2 - ON/OFF switch
3 - Speed control
4 - Dust extraction flow control
5 - Auxiliary handle
6 - Rubber drilled velcroed plate,
7 - Paper clamping lever
8 - Motor ventilation slots
9 - 29 mm Ø suction port
10 - Heat protection
11 - Heat protection fixing screws
3 axis vibration level
a h
Uncertainty
Uncertainty
2
m/s
3
5,75
1,5
STARTING UP
WARNING
Pay attention to the mains voltage! The mains voltage must
correspond to the voltage indicated on the technical data identification
place (1).
DANGER
Before any intervention on the electrical tool take the plug out
from the socket
BEFORE STARTING THE TOOL
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been damaged
during storage or transport;
- the tool is complete; check that the number and type of components comply
with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in the table
and that indicated on the tool identification plate reproduced;
- the power supply cable and plug are in perfect condition;
- the ON/OFF (2) switch works properly though with the power supply
disconnected;
- all the parts of the tool have been assembled in the proper manner and that
there are no signs of damage;
- the ventilation slots (8) are not obstructed;
- the tool must be connected to a suitable and efficient aspiration device.
ASSEMBLY/REPLACEMENT OF THE ABRASIVE PAPER SHEET
ASSEMBLY:
ABRASIVE VELCRO PAPER
- Press the velcro backed abrasive paper in position, ensuring that the holes in
the paper coincide with the suction holes in the prefored rubber plate (6);
- make sure that there is no dust or other matter on the prefored rubber plate (6).
ABRASIVE PAPER
- insert the abrasive paper clamping lever (7) by pressing the lever release;
- repeat this operation on the opposite side of the plate, keeping the abrasive
paper taut and checking that the edges are parallel with the edges of the
prefored rubber plate (6) before releasing the paper clamping lever (7);
9

Publicidad

loading