MESTO 3132 Serie Manual De Instrucciones página 4

EN
Technical data
Type of Max. filling
device quantity
3132... 1.5 l
Welcome and congratulations
for purchasing your new pressure sprayer.
Thank you for the trust you have shown in our brand.
Intended Use
Pressure sprayers 3132GT 1.5 l are designed for spraying detergents,
disinfectants, anti-corrosion agents, impregnating agents and other care
products.
Not suitable for, and not to be used under any circumstances for:
• Wetting agents (surfactants), solvents, and liquids containing solvents
which can cause or promote cracking in the applied plastics.
• highly viscous or sticky liquids or liquids that leave residue which
cannot be completely rinsed out of the device.
When using highly flammable and flammable liquids, always follow the
safety instructions of the agent manufacturer. Products other than those
approved by the manufacturer as well as
usage for purposes excluded above are not in conformity with proper use.
The manufacturer shall not be liable for any resulting damages or for
unauthorized modifications to the device.
Your Safety
Do not leave the device in the sun.
Check each time before using:
• Are all parts that are under pressure and convey liquids free of
damage?
• Are those parts functioning properly?
Replace devices that are damaged or not functioning properly
immediately.
Follow the spray manufacturer's instructions.
2293375
Original operating instructions
Total Max.
contents pressure
1.60 l 3 bar
Max. Weight
temperature when empty
30 °C 740 g
Do not leave under pressure for an extended period of time.
Never direct spray at persons, animals, or bodies of water.
Do not unscrew the pump from the tank when device is under pressure.
Do not blow through clogged nozzles or valves with your mouth.
Making the Device Ready for Use
• Unscrew the pump from the tank.
• Add spraying liquid to the tank up to the filling line.
• Screw the pump tightly onto the tank.
• Generate pressure in the tank by activating the pump
(max 15 pump strokes).
Use
• Undo the lock on the handle and set it to continuous spraying (Fig. 7).
• Using the lock the lever on the shut-off valve can be locked and unlo-
cked. Unintentional spraying is prevented after locking. (Fig. 8)
• If required, reset the lock and activate the shut-off valve. (Fig. 8)
• The shut-off valve must open and close.
After Usage
• Unscrew the pump from the tank.
• Never leave liquid in the device.
Empty and rinse the device with clear water.
• Do not dispose of residue as wastewater through the drain!
Dispose of surplus environmentally harmful products as hazardous
waste.
MESTO Spritzenfabrik Ernst Stockburger GmbH
Ludwigsburger Straße 71, D-71691 Freiberg/Neckar, www.mesto.de
Material of Max. flow rate
tank
Polyethylene 0.80 l/min/3 bar
0222