Milwaukee 1696891 Manual Del Operario página 5

Maintenance
Periodically check the cultivator for misalignment, binding
of moving parts, breakage of parts and any other condition
that may affect the cultivator operation. If damaged, have
the unit repaired before use.
Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to bind
and are easier to control.
All maintenance, repair and inspection work should be
performed by an authorized service center.
Maintenance Chart
Refer to the following table for routine maintenance.
Requirements Actions
Visual inspection
Cutting
Inspect and
System
check assembly
Check
All accessible
fasteners
Retighten
Troubleshooting
The following chart lists problems, causes and corrective
actions if your cultivator does not operate properly. If these
do not correct the problem, contact an authorized service
center.
Problem
Motor runs but
blades remain
stationary
Cutting tool too hot
Excessive vibration
After
Before
start
finish
• •
•
•
• •
Possible Cause
Drive cables not engaged.
Dull cutting blades.
Loose fasteners.
Correction
Disconnect the poles; make sure the drive cables engage
as poles are connected.
Replace the blade assembly.
Tighten fasteners.
en 5