Mafell ERIKA 70 Manual De Montaje página 16

5 Extension table 208438/ 208439
Use the extension table to saw larger workpieces. This
increases the supporting surface of the workpiece and
thus makes sawing easier.
Danger
If the extension table is loaded too
much, there is a risk of the circular
saw bench overturning.
5.1 Installation extension table
Danger
Only carry out adjustments on the
extension table when the saw
blade is stationary and the mains
plug has been unplugged.
The extension table 22 (Fig. 12) is usually installed on
the right hand side of the table top as follows:
•
Clean the dovetail guides at the table top and at
the two support rails 23 with a clean cloth.
•
Slide the support rails from the side into the
dovetail guide so that the scale can be read from
above.
•
Slide the support rails into the desired position. It
would make sense if the two zero points of the
scales matched at this point.
•
Tighten the cylinder-head screws 24 (Fig. 13) in
the area of the table top with a hexagon socket
wrench (AF5).
•
Push the extension table 22 (Fig. 12) between
the support rails.
•
Tighten the remaining cylinder-head screws 24
(Fig. 13) in the area of the extension table.
-16-