Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARING
1. Remove the sealing cap from the air inlet.
2. Mount the quick coupling nipple on the air inlet.
3. Put a few drops of compressed air device oil into the device via the air inlet.
4. Make sure that the trigger lever (2) is in the non-depressed position.
5. Connect the device to the compressed air source hose.
6. Check the function of the device by folding the safety lever (3) and pressing the trigger lever (2).
7. Disconnect the device from the compressed air source again.
USE
1. Disconnect the device from the compressed air source.
2. Fix the output shaft with one of the two open-end spanners.
3. Relax the chuck by turning the chuck sleeve anti-clockwise by using the second open-end
spanner.
4. Insert the drive shaft of the desired tool into the chuck and rotate the chuck sleeve clockwise
while locking the output shaft. For this using the two open-end spanners.
5. Make sure the tool is firmly seated in the chuck.
6. Connect the air tool to the compressed air source.
7. Check the function of the device by folding the safety lever (3) and pressing the trigger lever (2).
8. The air tool is now ready to be used.
TROUBLESHOOTING
Probable Cause
Dirty or clogged air passages
Insufficient air supply
Air leakage
Worn/damaged wear & tear parts
Tool matching
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information. Dispose
of this product at the end of its working life environmentally.
NOTES
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
(Insufficient power)
Flush and lubricate tool, drain air tank and supply line
Increase line pressure, make sure compressor matches
tool's air pressure and consumption needs
Use teflon tape at all fittings and joints.
Check tool for worn or damaged o-rings & seals.
Replace as necessary
Be sure you are using a tool suited for the sanding
requirements of the job at hand.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Solution
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
