Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions for Table-top Display
Tools required: Hex wrench (provided), Phillips screwdriver, stud finder, pencil, tape measure, power
17. Position the assembled stand at the desired location against a wall. If necessary, adjust the
pre-attached Floor Levelers at the bottom of both Legs (D and E) to level the unit. Now, follow
the instructions printed on the plastic bag containing the Tipping Restraint Hardware to attach
the tip-over restraint between the Spine and the wall.
NOTE: The tipping restraint hardware included is for wooden stud wall construction. It must be
attached to a wall stud. Depending upon your wall construction, different anchor hardware
maybe required. Please contact your local hardware store for assistance. Young children can
be seriously injured by tipping furniture. You must install the Tipping Restraint Hardware with
the unit to prevent the unit from tipping, causing any accidents or damage. The tipping
restraints are intended only as a deterrent, they are not a substitute for proper adult
supervision. The tipping restraints are not earthquake restraints. If you wish to add the extra
security of earthquake restraints, they must be purchased and installed separately.
18. The table-top stand is now ready for use. Be sure to position your Flat Panel TV in the center
of the console.
NOTE: If you choose the Tilting Wall Mount configuration, proceed to PAGE 26.
drill and 1/8" drill Bit.
15
TV
Publicidad
