Glacier bay 67575W-6001 Guía De Instalación Y Cuidado página 6

Installation (continued)
5
Preparing the pop-up assembly
□
Remove the stopper (K) and ange (L).
□
Screw the nut (N) all the way down, and push
the gasket (M) down.
M
N
K
L
6
Installing the pop-up body and
pop-up flange
□
Apply silicone to the underside of the ange (L).
□
Insert the pop-up body (O) into the sink. Screw
the ange (L) onto the pop-up body (O). The
pivot hole (1) must face the back of the sink.
□
Use the groove joint pliers to tighten the nut (N),
but do not over tighten. Do not turn the pop-up
body (O) while tightening the nut (N) or the
sealant may not seal properly. Clean away any
excess putty.
□
Open the easy install rotating clip (P).
N
6
L
O
1
Open
P