Whispbar Q Serie Instrucciones De Montaje página 5

EN
Q-Series Tracks
Q1-Q10
Use drill bit supplied, to drill rivet holes in
marked positions.
Take care not to drill too deep.
Remove masking tape and apply silicon
sealant around drilled holes.
Sit tracks on roof and line up tracks with
drilled holes.
Insert rivets through the tracks and into
drilled holes.
Fit pop rivet nozzle supplied with tracks to
your rivet gun.
Note: It is a standard thread to fit most rivet
guns. Use low pressure on air rivet guns.
Ensure that the front plugs are at the front
of the track and rear plugs at the rear.
Rivet tracks to roof.
5