Publicidad
Idiomas disponibles
Idiomas disponibles
Stop using multi-component detergents
Add special salt and rinse aid to dispensers.
Set the water hardness to the highest level (6) and run an empty dishwasher.
Adjust the water hardness.
Adjust rinse aid setting.
Add rinse aid to the dispenser and adjust setting
8
Use rinse aid to prevent the formation of white water drops, lime scale spots, white
streaks that may occur on the dishes, as well as to improve the drying process. Con-
trary to popular belief, it not only serves to obtain a shiny dishes, but also to facilitate
drying. For this reason, make sure there is always sufficient amount of rinse aid in the
dispenser.
Remove the rinse reservoir cap by
lifting up the handle
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to adjust the
consumption by user. Follow the below steps.
1. Open the door. Power on the dishwasher by plugging in;
2. Within 60 seconds after step 1, press the Program button more than 5 seconds, and then press the
Delay Button to enter the set model, the rinse aid indication blinks as 1Hz frequency.
3. Press the Program button to select the proper set according to your using habits , the sets will change
in the following sequence: D3->D4->D5->D1->D2->D3. Dispenser drops more rinse aid in D5 level than
in another, the manufactory setting is D3.
4. Without operation in 5 seconds or press the power button to exit the set model, the set success.
110
Pour the rinse aid into the
dispenser,
being careful not to
overfill.
Close the cap after all.
Publicidad
