Zanussi ZWI 71000 WA Manual De Instrucciones página 13

Replace the drawer and run the rinse programme with-
out any clothes in the drum.
Cleaning the pump
The pump should be inspected regularly and particularly
if:
• the appliance does not empty and/or spin;
• the appliance makes an unusual noise during draining
due to objects such as safety pins, coins etc. blocking
the pump;
• a problem with water draining is detected (see chapter
"What to do if..." for more details).
Warning! Before opening the pump door, switch the
appliance off and remove the mains plug from the
socket.
Proceed as follows:
• Unplug the appliance.
• If it is necessary, wait until the water has cooled down.
When no more water comes out, unscrew the pump
cover by turning it anti-clockwise and remove the filter.
Use pliers, if necessary. Always keep a rag nearby to
dry up any water spillage when removing the cover.
Clean the filter under a tap, to remove any traces of fluff.
www.zanussi.com
Place a container close to
the pump (A) to collect
any spillage.
Pull out the emergency
emptying hose (B), place it
in the container and re-
move its cap.
Caution! When the appliance is in use and
depending on the programme selected there can be
hot water in the pump.
Never remove the pump cover during a wash cycle, always
wait until the appliance has finished the cycle, and is
empty. When refitting the pump cover, ensure it is
securely re-tightened so as to stop leaks and young
children being able to remove it.
Cleaning the water inlet filters
Important! If the appliance doesn't fill, takes long to fill
with water, the starting button blinks yellow or the display
(if available) shows the relevant alarm (see chapter "What
to do if..." for more details), check if the water inlet filters
are blocked .
To clean the water inlet filters:
Remove foreign bodies
and fluff from the filter seat
and from the pump impel-
ler.
Check carefully whether
the pump impeller rotates
(it rotates jerkily). If it
doesn't rotate, please con-
tact your Service Centre.
Put the cap back on the
emergency emptying hose
and place the latter back in
its seat.
Replace the filter into the
pump by inserting it cor-
rectly into the special
guides. Screw the pump
cover firmly by turning it
clockwise.
• Turn off the water tap.
• Unscrew the hose from
the tap.
• Clean the filter in the
hose with a stiff brush.
13