Publicidad
Idiomas disponibles
Idiomas disponibles
SM 1619X09207 9-14_SPT77WM WML 9/12/14 7:05 AM Page 9
ATTACHING THE BLADE
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting
the tool accidentally.
1. Press the lock button and turn wrench until
lock button engages. Saw shaft is now locked.
Continue to depress button, turn wrench
clockwise and remove BLADE STUD and
OUTER WASHER (Fig. 2).
2. Make sure the saw teeth and arrow on the
blade point in the same direction as the arrow
on the lower guard.
3. Retract the lower guard all the way up into
the upper guard. While retracting the lower
guard, check operation and condition of the
LOWER GUARD SPRING.
4. Slide blade through slot in the foot and
mount it against the INNER WASHER on the
shaft. Be sure the large diameter of the INNER
and OUTER washers lay flush against the blade.
UXILI RY H NDLE
UPPER GU RD
FIG. 2
LOCK
BUTTON
Assembly
5. Reinstall OUTER WASHER. First tighten
BLADE STUD finger tight, then TIGHTEN
BLADE STUD 1/8 TURN (45˚) WITH THE
WRENCH PROVIDED.
Do not use wrenches with longer handles,
since it may lead to over tightening of the
blade stud.
VARI-TORQUE CLUTCH
This clutching action is provided by the friction
of the OUTER WASHER against the BLADE
and permits the blade shaft to turn when the
blade encounters excessive resistance. When
the BLADE STUD is properly tightened (as
described in No. 5 of Attaching The Blade), the
blade will slip when it encounters excessive
resistance, thus reducing saw's tendency to
KICKBACK.
One setting may not be sufficient for cutting all
materials. If excessive blade slippage occurs,
tighten the blade stud a fraction of a turn more
(less than 1/8 turn). OVERTIGHTENING THE
BLADE STUD NULLIFIES THE EFFECTIVE-
NESS OF THE CLUTCH.
LOWER GU RD
SPRING
LOWER
GU RD
BL DE
OUTER W SHER Large Diameter
Faces Blade
-9-
LOWER GU RD
LIFT LEVER
S W SH FT
INNER W SHER
Large Diameter Faces Blade
BL DE
STUD
Tighten
Loosen
Publicidad
