Urmet 1083 Manual De Configuración página 22

5. DEVICE PARAMETER SETUP
FROM THE Urmet CallMe APP
To set up the parameters of your device, firstly create
an account (or log in using an existing account), as
explained in the "CREATE A NEW ACCOUNT OR USE
A SAVED ACCOUNT" section.
From the Home Page, (with the green dot
and chain closed ) select the "Settings" key.
You will display:
Installation and maintenance
Service management
Settings Menu
Press the "Installation and Maintenance" button. The
following screen will appear:
Device configuration
Device replacement
Post-installation test
Installation and maintenance
Select the "Device configuration" button here.
22
displayed
User account
Configure app
Exit
Follow the steps below:
1. Turn on the Multi-User Call Forwarding Device.
IMPORTANT: The device is already in configuration
mode the first time it is switched on (it will take about
50 seconds before the red LED starts blinking) go
directly to step 3.
2. Hold the button pressed on the call forwarding
device for 2 to 4 seconds to set it in configuration
mode. The yellow LED will light up.
3. Press the 1083/83 button to configure the Multi-
User Call Forwarding Device.
Select the device to be configured
4. Scan QR code on the device.
QR-Code scan request
DS1083-122A