Publicidad
Control Assembly Instructions
1. Remove screw (A) and washer (B) from spindle
2. Position cross top (C) to tap body and assemble anti-rotational washer (B)
followed by screw (A).
Note: It is imperative that the anti-rotational washer is installed
3. Levers are also available (Assembly method is identical). Position lever at the
preferred angle.
4. Using a flat edge screwdriver (E), tighten the screw (A) down against the
anti-rotational washer (B) to its fullest extent.
5. Insert the indice (D) to complete assembly.
Publicidad
