Publicidad
STEP 14
6
(x22)
Carefully turn your unit over on its front side as shown. Assure the your unit is square. Distance from
corner to corner is equal. Position back panel as shown. Flush bottom edge of back panel with
bottom edge of the bottom shelf. Align back panel squarely and nail straight into back edges as
shown.
Now tighten screws in angle brackets (4) that were left loose in step 8.
ameriwoodhome.com
IMPORTANT! THE BACK PANEL IS A STRUCTURAL
PART OF THIS UNIT AND MUST BE INSTALLED
PROPERLY.
"Raw Surface Shown"
Flush bottom edge of the back
panel with the bottom edge of
bottom (E).
21
6
Publicidad
