Descargar Imprimir esta página

Makita BBX7600N Instrucciones De Manejo página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
1. Starting
• Never attempt engine start in a place where the fuel has been supplied.
- It may cause ignition or fire. When starting the engine, keep a distance of at least 3 m.
• Exhaust gas from the engine is toxic. Do not operate the engine in a poorly-ventilated place, such as in a tunnel, building, etc.
- Operating the engine in the poorly-ventilated place may cause poisoning by exhaust gas.
• In case of detection of any abnormality in sound, odor, vibration after starting, stop the engine immediately and carry out inspection.
- If the engine is operated without attending such abnormality, an accident may occur.
• Make sure that the engine stops when the stop switch is set to "O" position.
1) When the engine is cold or after refuelling
(1) Set this machine on a flat space.
(2) Set the stop switch to " I " position.
(3) Make sure that the cruise control lever is in the low-speed
position.
(4) Continue to push the primer pump until fuel comes into the
primer pump.
• In general, fuel comes into the carburetor by 7 to 10 pushes.
• If the primer pump is pushed excessively, an excess of
gasoline returns to the fuel tank.
(5) Lift the choke lever to the closed position.
(4)
Primer pump
Choke lever
(6) Hold the element cover with left hand to prevent the engine
from moving.
(7) Pull out slowly the starter handle till a certain resistance is felt.
Return the starter handle backward once from this position,
then pull it out with force.
• Never pull the rope to the full extension.
• Once the start knob is pulled, never release your hand
immediately. Hold the start knob until it returns to its original
point.
(8) When the engine starts, open the choke lever.
• Open the choke lever fully when checking the engine oper-
ation.
• In cold or when the engine is cooled down, never open the
choke lever suddenly. Otherwise, the engine may stop.
(9) Continue warm-up operation for 2 to 3 minutes.
(10) Warm-up is complete when there is quick engine acceleration
from low rpm to full throttle.
(5)
Close
WARNING
(2)
(3)
Cruise control lever
(7)
(8)
12
Stop Switch
Hi-speed
Low-speed
Open

Publicidad

loading