Publicidad
Idiomas disponibles
Idiomas disponibles
Gas installation
01. This range was designed for use with
LP gas .
02. Always use a pressure regulator
exclusive for your gas range. The
lack of pressure regulator might
cause excess of pressure and leak of
gas. Always check for the validity of
the pressure regulator. Hose and
regulator should be replaced every 5
years.
Technical specification of the
pressure regulator:
• Pressure: 200 mm C. A.
• Max. consumption: 2 kg/h
03. Always use a PVC hose to work from
-20ºC to 100ºC. Be sure that hose:
• does not have joins.
• does not go on the back of the gas
range neither close to the hot air
exits.
• its less than 125cm long.
04. If possible, install the gas cylinder
outside the kitchen, in a place
protected and with air flow.
05. Use a 1/2"metallic hose to connect
to the gas range using a L coupling
connector.
06. Only use a plastic hose when this
one does not go on the back of the
gas range.
Installation
41
Pressure regulator
Metalic flexible tube
L coupling
connector
Attention
If you have any doubt or need to
buy any accessory for the
installation, please contact our
authorize service.
Hose installation
01. Place the metal clamp on the hose end.
02. Connect the hose to the oven connector and tight the clamp.
03. Place the other clamp on the opposite hose end and connect it to the
pressure regulator. Tight the clamp.
04. Bolt the pressure regulator to the gas cylinder carefully.
05. After the installation, check if there is any gas leak, using soap or liquid
detergent foam
Connector
Plastic Hose
Installation
42
Publicidad
