Escalade Sports Stiga Play The Best T8611 Manual Del Propietário página 2

CAUTION :
DO NOT USE POWER TOOLS TO DRIVE SCREWS INTO
WOOD TOPS. HAND TIGHTEN SCREWS ONLY .
TIGHTEN SCREWS SNUG, BUT DO NOT OVER-
TIGHTEN, CAUSING SCREWS TO STRIP IN WOOD.
1. Lay table top #1 painted side down, on a smooth, flat
surface. Use the shipping container to protect the
painted surface of the table top.
2. Assemble the two "L " tubes and the center tubes that
make up the "U" Support and the "U" Leg. Align on
T able T op as shown in Figure 1. Note: "U" Leg is
larger and wider than the U Support. The U-
leg should be installed on the end of the table
half with the end stripe on top side
3. Put plastic caps #13 on the end of U-leg #2.
CAUTION:
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-
CLIPS (#3) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED
INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE
WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.
If you want to see a video on how to position the U-Clips go to:
http://www.escaladesports.com/customer-service/videos.html
4. Align the holes in the Large U-clips #3 with pilot holes in
table top assembly and secure with twenty four screws #20
as shown. All four holes in each U-Clip must align with four
pilot holes in top.
IMPORTANT:
Be sure that slot in the six U-clips #3 all face the same
direction (toward the middle of the table with the U-
support) as shown.
3
All manuals and user guides at all-guides.com
This end is the middle of the table
and has no stripe or pilot holes.
The middle of the table is the end that
does not have the stripe on top.
Figure 1
13
Stripe on End
U-Leg
This end will be the
middle of the table when
completely assembled.
20
3
3
3
IMPORTANT: U-Leg is wider than U-support.
Make sure they are assembled exactly as
shown. If not, there will be a large gap between
table halves and table will not operate properly!
2
7
U-Support
2
All screws shown
are (#20) sheet
metal screws.
3
3
13
3
7
U-support
2
U-Leg
Figure 2