Front Runner FAFR004 Manual De Instrucciones página 6

2 FIT AND SECURE
2.10
2.11
2.12
FAFR004_REV_A01
REMOVE
75mm
205mm
1265mm
1370mm
90mm
MODELS WITHOUT FACTORY MOUNTED RAILS
Starting at the top edge of the vehicle's
windscreen, measure and mark the
dimensions as shown onto each of the
ditch trim pieces.
Remove the two trim pieces and cut on
each of your markings. Make sure to mark
the various pieces so that you are able to
place them back in their correct positions.
Refit the ditch trim pieces in place using
double sided tape NOT SUPPLIED.
Make sure the ditch & trim is clean before
applying the tape.
Remove the two trim pieces and store for
future use.
Starting at the top edge of the vehicle's
windscreen, measure and mark the
dimension as shown onto both LH / RH
ditch centre's.
Place the foot rail on the vehicles roof
lining up the front slot centre with the
mark you made earlier and mark the
centre of the remaining 3 slots.
Repeat this step with the opposite side.
Drill the 8 holes you marked, starting with
a 4mm pilot hole before going to the 6mm
hole. There is no need for a lot of
downward pressure. Let the drill do the
work.
Apply anti-rust to all the holes drilled.
6
DITCH TRIM OPTION
NO TRIM OPTION
13mm
© 2021 FRONT RUNNER VEHICLE OUTFITTERS