Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks. Do not lose
the gasket (1) in the hose.
□
Pull the hose assembly out of the spout and
remove the spray head by unscrewing it from
the hose in a counterclockwise direction. Be
sure to hold the end of the hose down into the
sink and turn the faucet to the warm position
where it mixes hot and cold water.
□
Flush the water lines for one minute. This ushes
away any debris that could cause damage to
internal parts. Check for leaks.
□
Re-tighten any connections if necessary, but do
not overtighten. Reinstall the spray head by hand
tightening it back onto the spray hose in a
clockwise direction.
2
Removing the quick connector
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
1
Squeeze
1
7
Please contact 1-855-HD-GLACIER for further assistance.
2
Pull
down
1
HOMEDEPOT.COM
Publicidad
