Waeco CAM10 Instrucciones De Montaje Y De Uso página 31

CAM10, CAM10C
Observe the fastening instructions:
– There must be sufficient space for the mounting procedure behind the chosen in-
stallation location.
– Suitable measures must be taken to prevent water penetrating through any holes
made (e.g. by using screws and sealant and/or spraying the outer attachment parts
with a sealant).
– The location on the body where you wish to attach the camera must be rigid enough
to allow the camera to be tightly fastened.
Check beforehand that there is sufficient room for the drill head to come out on the oth-
er side (fig. 2, page 4).
If you are not sure about the location you have chosen, consult the vehicle manufac-
turer or dealer.
Note
I
We recommend greasing the threads of the bolts to prevent corrosion.
When mounting the camera, proceed as follows:
➤ Hold the camera on the chosen location and mark at least two different points for the
drill holes (fig. a, page 7).
➤ Using a hammer and centre punch, gently pre-punch the previously marked points to
prevent the drill head from slipping off.
If you want to screw on the camera with self-tapping screws (fig. b, page 7)
Caution!
a
The holder may only be attached to steel panels with a minimum thickness of
1.5 mm using self-tapping screws.
➤ Drill Ø 4 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the 5 x 20 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted through the
construction (fig. c, page 7)
Caution!
a
Ensure that that nuts cannot be pulled through the body shell when they are
tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 5.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer threaded
screws.
Mounting the camera
31