Waeco CAM10 Instrucciones De Montaje Y De Uso página 34

Mounting the camera
Observe the following instructions when laying the connection cable:
Note
I
Feed the connection cable through existing ducts or other openings where pos-
sible e. g. ventilation grilles. If no appropriate ducts or openings are available
you will need to drill a hole of ∅ 20 mm. Check beforehand that there is sufficient
space on the other side for the drill head to come out (fig. 2, page 4).
Note
I
Please observe the notes from the chapter "General information on the electrical
connections" on page 28
➤ Lay the monitor cable on the dashboard.
➤ Insert the plug of the monitor cable (2) in the socket (4) of the connection cable (3).
Caution!
e
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cables to a suitable
voltage source:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If necessary, connect the mini DIN socket (7) of the connection cable to the
mini DIN plug (10) of the system cable (11).
➤ Connect the mini DIN socket (12) of the system cable (11) of to the mini DIN plug (13)
of the camera cable.
➤ Connect the green cable (9) to the positive cable of the reversing light.
Note
I
If a voltage is present on the green cable, the monitor is switched on automati-
cally and the camera is activated.
7.5 Setting the camera (fig. g, page 9)
➤ Switch the monitor and camera on.
➤ The monitor image should show the bottom edge of the rear or the bumper of your
vehicle (A). The middle of the bumper should be in the middle of the screen. Turn the
camera in the camera holder (B) to correctly set the camera.
➤ When you have set the camera properly, tighten the 6 fastening bolts.
Caution!
a
The camera's plug connection is not protected against moisture. It is essential
that you wrap insulating tape around the connection to prevent damage.
34
CAM10, CAM10C