Publicidad
Idiomas disponibles
Idiomas disponibles
You can repeat this for the Listen to Music and Watch
Movie Activities, replacing the second digit with the
brand of Blu-ray player or Streaming box, as long as
they are listed above. If not, you should use the
SimpleSet or Code Setup methods listed earlier.
Using the AV shift
The INPUT button selects the input on your TV (most
TVs use a menu to select from a list of inputs). When
the INPUT button is pressed in an Activity, the MENU
,
,
seconds) control the TV. If the OK button is pressed, or
no button is pressed for 10 seconds, these buttons
revert to controlling the relevant device for the Activity
(for example STB in the Watch TV Activity).
Using the power macro
If you press and hold the
seconds in any Activity, your remote sends the power
signal to each device within that Activity. For example,
pressing the
for the Watch TV Activity turns both the TV and set top
box on or off.
Troubleshooting
CAUTION: Do not try to repair your remote yourself. Doing
so invalidates the warranty.
PROBLEM
The LED does not
turn on when a
button is pressed.
The LED turns on,
but my remote
does not control
my device.
I have tried all of
the codes for my
device's brand, but
none of them work.
20
,
,
and OK buttons temporarily (for 10
(power) button in the default setting
SOLUTION
Replace the batteries.
• Make sure that your remote is
• Make sure that your remote is set to
See Setup method 2 - device codes on
page 11.
www.insigniaproducts.com
(power) button for two
programmed to your device.
the correct mode (TV, STB, STREAM,
AUDIO, AUX, or BLURAY).
Publicidad
