Descargar Imprimir esta página

Ecco K7010-K Instrucciones De Instalación página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

Caution!
!
When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel lines, vehicle
upholstery, etc. that could be damaged.
Notes:
1. Larger wires and tight connections will provide longer service life for components. For high current wires it is
recommended that terminal blocks or soldered connections be used with shrink tubing to protect the connections. Do
not use insulation displacement connectors (e.g., 3M Scotchlock type connectors)
2. Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices
to reduce voltage drop. High ambient temperatures (e.g., under-hood) will significantly reduce the current carrying
capacity of wires, fuses, and circuit breakers. All wiring should conform to the minimum wire size and other
recommendations of the manufacturer and be protected from moving parts and hot surfaces. Looms, grommets,
cable ties, and similar installation hardware should be used to anchor and protect all wiring.
3. Fuses or circuit breakers should be located as close to the power takeoff points as possible and properly sized to
protect the wiring and devices.
4. Particular attention should be paid to the location and method of making electrical connections and splices to protect
these points from corrosion and loss of conductivity.
5. Ground termination should be only be made to substantial chassis components, preferably directly to the vehicle
battery.
6. Circuit breakers are very sensitive to high temperatures and will "false trip" when mounted in hot enviroments or
operated close to their capacity.
Installation, Wiring and Function
Installation:
Camera Model EC7010-K
Important! Mount the camera at a location that provides the best view of the area immediately behind the vehicle.
Generally, mounting locations toward the top of the vehicle provide the best field of view. Lower mounting locations
reduce the field of view and increase the likelihood of damage from road spray.
1. Find an appropriate location for installation.
2. Drill holes according to the size of U-bracket and fix the U-bracket.
3. Drill a 3/4" (19mm) hole next to U-bracket.
4. Install the camera on U-bracket.
5. Connect the camera tail with the extension cable from inside the vehicle.
6. Loosen the hex head screws and adjust the camera's position to get the best view angle in the monitor.
Wiring:
Important! Waterproof all connections whether inside or outside the vehicle by using sealant and wrapping with
insulation tape. Wrap tape tightly, overlapping by one-half widths so there are no gaps.
Page 2 of 4
P/N 920-0641-00 (Rev A) 2017-03-23
© 2017 at ECCO
Picture depicted is for reference only.
4 pin connector
7-inch monitor
4 pin connector
20m extension cable
12V-24V
Ground
Camera

Publicidad

loading

Productos relacionados para Ecco K7010-K